Welders For Home Use

Buy Welders For Home Use and Wire Feed Welders

Mig Welding

By admin

My Mig Welding Technique
By Flynn Powers

This article is to break down and show you the step by step process on how to create a perfect mig weld and explains the techniques involved.

Every time I’m mig welding I mainly don’t pulse, stitch, or push the weld.

I try not to stitch weld because you commonly are rarely getting the penetration you require

I don’t push from right to left due to the fact its harder to get penetration since the weld is being sent away from the molten puddle unlike the pulling technique where your wire is pushing in into the molten puddle furthermore the mig weld is allot more difficult to control to make the weld look attractive.

The main mig welding procedure I use is rather different than various other methods for example “C” or “e” though I actually do makes use of the “e” in common situations The technique I personally use is actually a back and fourth movement while pulling left to right ( if you’re left handed the contrary applies) with the nozzle of the gun with a forty five degree angle. I target the wire down the middle of the joint the spot where the 2 metals meet.

I may make use of a “e” formation if there is a thicker piece of metal on one side compared to other in that instance I’ll push the weld in a “e” configuration in direction of the thicker part.

Hand Speed and Hand Position

Lets start with the Hand placement

- keep the trigger area of the gun with your right hand with the ability to swivel your wrist ( similar to the throttle of a motorcycle)

- you’re going to want to lay the actual bend of the gun in between the pointer finger and thumb while using the top of your hand resting on the bench.

- your left hand will be the point for the gun to be able to rotate upon and also to secure the nozzle.

-your right hand is going to be the component which twists to achieve the backward and forward motion that forms your mig weld beads.

- In addition you’re going to want to relax your arms as well as hands so you can glide your left hand along the table to follow the weld down the joint.

Hand Speed

I remember when I was initially beginning out I was basically always mig welding like I was in a rush but you don’t want to, you should relax your hold ( the gun is not going anywhere)

-When you start out the weld, relax! Perform a nice small cycle to close off the end of the material.

- After that pull to the right roughly a about half in, or less in a partial rapid motion.

- And then push the puddle back over what weld i recently laid down using a slower pace and watch the bead create a nice round puddle.

- Whenever i push back i observe the space of the bead before and try and match up with the stopping point of the puddle I did earlier and that is precisely how I know how far I want to push back the puddle.

If you are interested in more mig welding tips and techniques check out ProFabricationTechniques.com/Mig welding

http://www.profabricationtechniques.com/mig-welding

Article Source: http://EzineArticles.com/?expert=Flynn_Powers

http://EzineArticles.com/?My-Mig-Welding-Technique&id=5866473